Zinc Shot
-
Payment
-
Origin
China Mainland
-
Minimum Order
1
-
Packing
Pieces
- Contact Now Start Order
- Description
Product Detail
- Steel Shots S390 5 Pieces / (Min. Order)
- Steel Shots S230 5 Pieces / (Min. Order)
- Brown Aluminum Oxide for Refractory 5 Pieces / (Min. Order)
- Steel Cut Wire Shot 1.5mm for Shot Blasting 5 Pieces / (Min. Order)
- Material SUS430 Stainless Steel Shot - 0.8mm for Surface Preparation 5 Pieces / (Min. Order)
- Steel Shot S660 With Good Quality 5 Pieces / (Min. Order)
- Steel Grits For Sandblasting 1 Pieces / (Min. Order)
- Stainless Steel Cut Wire Shot 1 Pieces / (Min. Order)
- Steel Shot 1 Pieces / (Min. Order)
- Cast Steel Shot 1 Pieces / (Min. Order)
- Cast Steel Grit 1 Pieces / (Min. Order)
- High Carbon Steel Shot 1 Pieces / (Min. Order)
- Bearing Steel Grit 1 Pieces / (Min. Order)
- S330 Steel Shot for Surface Preparation 1 Pieces / (Min. Order)
Product Description
Zinc shot is made with the process of drawing, cutting and conditioning . And used for deburing and cleaning on various Aluminum alloy, Zinc die castings. As specific gravity of zinc shot is close to steel but the hardness is low, the deburing can be performed without wearing the products' surfaces. Otherwise distinguished from Aluminum abrasive, the security is nice for much lower kinding point of the dust. And they are also characterized at obvious whitening on the surfaces of the work pieces.
Zinc cut wire shot abrasive offers a media of very low Rockwell B hardness (20 - 30) suitable for use in deburring die castings, is capable of removing flash up to .020 " from die castings.
Zinc shot also leaves a deposition of zinc on the work object that provides corrosion resistance.
Technical date:
Name |
Zinc shot |
Chemical analysis |
Zn:=99% |
Hardness |
45-50HV |
Tensile strength |
90-120MPa |
Ervin life |
6000 cycles |
Microstructure |
Deformed a-phase |
Density |
7.1g/cm3 |
Bulk density |
4.1g/cm3 |